76 Configuration: About Your Storage ArrayTo change the enclosure order in the Physical pane:1 In the AMW, select Storage Array Change Enclosure Order.2 From the enclosures list, select the enclosure you want to move and clickeither Up or Down to move the enclosure to the new position.3 Click OK.If you have set a password for the selected storage array, the EnterPassword dialog is displayed.4 Type the current password for the storage array.5 Click OK.Configuring Alert NotificationsMDSM can send an alert for any condition on the storage array that requiresyour attention. Alerts can be sent as e-mail messages or as Simple NetworkManagement Protocol (SNMP) trap messages.You can configure alert notifications either for all the storage arrays or a singlestorage array.To configure alert notifications for all storage arrays:1 In the EMW, select the Setup tab.2 Select Configure Alerts.The Configure Alerts dialog is displayed.3 Select All storage arrays.4 Click OK.The Configure Alerts dialog is displayed. To configure e-mail alerts, see"Configuring E-mail Alerts" on page 77. To configure SNMP alerts, see"Configuring SNMP Alerts" on page 79.To configure alert notifications for a single storage array:1 In the EMW, select the Devices tab.2 Select the relevant storage array, then select EditConfigure Alerts.The Configure Alerts dialog is displayed. To configure e-mail alerts, see"Configuring E-mail Alerts" on page 77. To configure SNMP alerts, see"Configuring SNMP Alerts" on page 79.
