Setting Up Your PowerVault NX3500 Solution 399 In the Select Capacity table, select the relevant disk group capacity, andclick Finish. Repeat the procedure for a minimum of two disk groups andthen proceed to "Creating Virtual Disks" on page 39.If you have selected Manual configuration, proceed to step 10.10 For manual configuration, the Manual Physical Disk Selection window isdisplayed.11 Choose the appropriate RAID level in Select RAID level. You can selectRAID levels 0, 1/10, 6, and 5. Depending on the RAID level chosen, thephysical disks available for the selected RAID level is displayed inUnselected physical disks table.12 In the Unselected physical disks table, select the appropriate physicaldisks and click Add.NOTE: You can select multiple physical disks at the same time by holding or and selecting additional physical disks.13 To view the capacity of the new disk group, click Calculate Capacity.14 Click Finish.Repeat the procedure for a minimum of two disk groups and then proceedto "Creating Virtual Disks" on page 39.Creating Virtual DisksNOTE: Before creating virtual disks, organize the physical disks into disk groupsand then create a virtual disk within each disk group.Create a minimum of two virtual disks dedicated for NAS storage. The NASstorage capacity can be expanded to a maximum of 16 virtual disks. Thenumber of virtual disks must increment in pairs.NOTE: Minimum virtual disk size required for the PowerVault NX3500 is 125 GB.
