Dell TrueMobile 2300 User Manual

Also see for TrueMobile 2300: Specifications Faq

No additional settings are required. Make sure that the settings listed above are correct for Cable Modemconnection.DSL Static IP SettingsIn the fields provided (listed below), enter the IP address, IP subnet mask, ISP gateway address, and DomainName Server (DNS) IP address provided by your ISP.IP assigned by your ISPIP Subnet MaskISP Gateway AddressDomain Name Server (DNS) IP AddressDSL PPPoE SettingsPoint to Point Protocol over Ethernet (PPPoE) is a proposal specifying how a host PC interacts with a broadbandmodem (i.e. xDSL, cable, wireless, etc) to access to the network. In many respects PPPoE is similar to the"Dialup Networking" approach. If you have an DSL (PPPoE) Internet connection, enter the PPPoE user nameand password (Retype password to confirm.) provided by your ISP.PPTP SettingsThe following settings should be provided to you by your Internet Service Provider (ISP).IP AddressSubnet MaskServer IP AddressUser NamePasswordIf your ISP specifies that you use PPTP (Point-to-Point Tunneling Protocol) as your connection to the internet, youcannot use the provided setup wizard to automatically setup your router. Remove the ethernet cable from theback of the computer you currently connect with, and connect it to the internet port of your router. Connect theethernet cable provided to any of the 4 LAN ports, and the other end to your computer. Configure yourcomputer's ethernet adapter to obtain an address automatically. See Windows Help for information on how toconfigure your computers network adapter.Click the NEXT button to continue.WARNING! If you are charged for your Internet Connection by the minute, unplug the networkcable from the Internet port on the Wireless Broadband Router when Internet access is nolonger desired.Back to TopSave & ApplyUse the Save & Apply page to submit all the network setting changes you have made. Click the Save & Restart button toupdate the network configurations for your Wireless Broadband Router. New settings are written to the firmware, and theWireless Broadband Router reboots automatically.NOTE: If you have wireless clients in your network, you must configure the clients' wireless network cards to matchthe settings for the Wireless Broadband Router.Back to TopBack to Contents Page