Replacing the Base Cover | 15Replacing the Base CoverWARNING: Before working inside your computer, read the safety informationthat shipped with your computer and follow the steps in "Before You Begin" onpage 9. After working inside your computer, follow the instructions in"After Working Inside Your Computer" on page 11. For additional safety bestpractices information, see the Regulatory Compliance Homepage atdell.com/regulatory_compliance.Procedure1 Replace the battery-LED board. See "Replacing the Battery-LED Board" on page 21.2 Slide the battery-LED-board cable into the battery-LED-board cable connector andpress down on the connector latch to secure the cable.3 Carefully turn the base-cover assembly over and snap the base-cover assemblyinto place.4 Replace the screws that secure the base-cover assembly to the palm-rest assembly.5 Replace the screws under the system badge that secure the base-cover assembly.6 Slide the tabs on the system badge into the slots on the base-cover assembly andsnap the system badge into place.
