40 | Removing the Power/Battery Status-Light BoardRemoving the Power/Battery Status-Light BoardWARNING: Before working inside your computer, read the safety informationthat shipped with your computer and follow the steps in "Before You Begin" onpage 9. After working inside your computer, follow the instructions in"After Working Inside Your Computer" on page 11. For additional safety bestpractices information, see the Regulatory Compliance Homepage atdell.com/regulatory_compliance.Prerequisites1 Follow the instructions from step 1 to step 7 in "Removing the Base Cover" onpage 12.2 Remove the speakers. See "Removing the Speakers" on page 22.3 Remove the battery. See "Removing the Battery" on page 25.Procedure1 Lift the connector latch and, using the pull-tab, disconnect thepower/battery-status-light cable from the system board.2 Note the location of the tape that secures the power/battery status-light cable tothe palm-rest assembly, and then peel the tape.3 Remove the screw that secures the power/battery status-light board to thepalm-rest assembly.
