Back to Contents PageWireless USB BoardDell™ XPS™ M2010 Service ManualRemoving the Wireless USB BoardReplacing the Wireless USB BoardThe wireless USB board provides the wireless connection for the remote controller.Removing the Wireless USB Board1. Follow the instructions in Before Working Inside Your Computer, including removing the system battery.2. Turn the computer over and open the display (see Opening the Display).3. Detach the keyboard by grasping the sides of the keyboard and pulling it straight out from the computer base. Set the keyboard aside.4. Remove the cosmetic covers (see Removing the Cosmetic Covers).5. Remove the top cover (see Removing the Top Cover).6. Disconnect the wireless USB cable from the system board.7. Remove the wireless USB board by removing the M2 x 3-mm screw.Replacing the Wireless USB Board1. Attach the new wireless USB board with the M2 x 3-mm screw.2. Connect the wireless USB cable to the system board.3. Replace the top cover (see Replacing the Top Cover).4. Replace the cosmetic covers (see Replacing the Cosmetic Covers).CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.CAUTION: Only products approved for use in your portable computer may be installed.NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of yourcomputer's electronic components. You can do so by touching an unpainted metal surface. If you leave the area, ground yourself again when you returnto the computer.NOTICE: To help prevent damage to the system board, remove the main battery before working inside the computer.1 wireless USB cable connector 2 M2 x 3-mm screw 3 wireless USB board