6. Replace the drive panel (see Installing the Drive Panel).7. Replace the computer cover (see Replacing the Computer Cover).8. Connect your computer and devices to electrical outlets, and then turn them on.Installing a CD/DVD Drive1. Follow the procedures in Before You Begin.2. Remove the computer cover (see Removing the Computer Cover).3. Remove the drive panel (see Removing the Drive Panel).4. Remove the existing CD/DVD drive, if applicable (see Removing a CD/DVD Drive).5. Prepare the CD/DVD drive for installation and check the documentation that accompanied the drive to verify that the drive is configured for yourcomputer.6. If no screws are attached to the drive, check the inside of the drive panel for screws and, if screws are present, attach the screws to the new drive.7. Gently slide the drive into the drive bay until you hear a click or feel the drive securely installed.1 drive-release latch 2 CD/DVD driveNOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.NOTE: If you are installing an IDE drive, configure the drive for the cable select setting.1 CD/DVD drive 2 shoulder screws (3)
