Delphi Display Systems RDS-INSFTTCU Configuration And User's Manual
                                                                                  | |
Contents
| 
Delphi Display Systems, Inc. RDS-INSFTTCU Page 32 of 82Confidential Document:Do not copy or distribute without written permission from Delphi Display Systems, Inc.Copyright 2012. [Unpublished Work]. All rights reserved4.9 DisconnectWhen you select Disconnect from the Menu Bar you are disconnecting from the session with your FastTrack ® Timer. The Disconnect in the Menu Bar becomes inactive and the Connect in the Menu Barbecomes active.4.10 Remote ControlThe Software application lets youmanage your Fast Track ® Timer(s) fromyour PC. When you select RemoteControl from the Menu Bar a newwindow along with the Connect to Sitedialog box opens up. Select the site youwant to run a Remote Control sessionwith then click Connect and OK todismiss the Connect to Site dialog box(See –Section 4.8 Connect).The Remote Control dialog box displaysthe Fast Track ® Timer site that you arecurrently connected to.The display to the right of the site you’reconnected to shows the Activity screenof the Fast Track ® Timer in real time.L1 through L8 are detection points.When Active (Red State) show thelocation of vehicle(s) in the Drive-Thru.Not all Drive-Thru stores are configuredthe same so, some detection points are not being used. (See - Section 2.6 LED Status Lights.)The Remote Control keypad is used to guide you through the Remote Control screens to access differentfunctions and commands for the Fast Track ® Timer. Your mouse pointer is used to operate the FastTrack ® Timer by moving the pointer over to the desired button of the keypad and clicking.The Print LCD allows you to print what is currently displayed on the Remote Control screen to yourdefault local or network printer.EXIT closes the Remote Control dialog box while maintaining your connection.The following pages will guide you with each screen and proper usage for manual operation.NOTE: Most of the operation performed in Remote Control can be easily done through Site Parameters.(See – Section 4.5 Unit Parameters.) |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine