ENGLISHGetting Started Connections Setup Playback InformationIf a problem should arise, first check the following:1. Are the connections correct?2. Is the set being operated as described in the owner’s manual?3. Are the other components operating properly?If this unit does not operate properly, check the items listed in the table below. Should the problem persist, there may be a malfunction.In this case, disconnect the power immediately and contact your store of purchase.TroubleshootingTroubleshootingSymptom Cause Countermeasure PageSet does not workproperly when remotecontrol unit operated.• Batteries are worn.• You are operating outside of the specified range.• Obstacle between main unit and remote control unit.• The batteries are not inserted in the proper direction,as indicated by the polarity marks in the batterycompartment.• The set’s remote control sensor is exposed to strong light(direct sunlight, inverter type fluorescent bulb light, etc.).• Replace with new batteries.• Operate within the specified range.• Remove the obstacle.• Insert the batteries in the proper direction, following thepolarity marks in the battery compartment.• Move the set to a place in which the remote control sensorwill not be exposed to strong light.33333GRemote Control UnitHSymptom Cause Countermeasure PageNo sound is produced.No image appears on themonitor.• The iPod is not playing.• The iPod is not properly connected to the ASD-3W.• The AC adapter is not connected to the ASD-3W or a poweroutlet.• The AV/Control cable is not properly connected.• The monitor’s input selection is not properly set.• Check that the iPod is playing.• Check that the iPod is properly connected to the ASD-3W’sdock connector.• Check the connections.• Check the connections.• Set the monitor’s input selector to the proper position forthe connected video input terminal.––777GGeneralH