Denon AVR-1803 Operating Instructions Manual

Also see for AVR-1803: Brochure & specs Operating instructions Operating instructions Operating instructions

Denon AVR-1803 Operating Instructions Manual Manual pdf 26 page image

ENGLISH26Setting the Auto Surround ModeFor the three kinds of input signals as shown below, the surround mode played the last is stored in the memory. At next time it the same signalinputs, the memorized surround mode is automatically selected and the signal is played.Note that the surround mode setting is also stored separately for the different input function.SIGNAL Default Auto Surround Modeq Analog and PCM 2-channel signals STEREOw 2-channel signals of Dolby Digital, DTS or other multichannel format Dolby PLII Cinemae Multichannel signals of Dolby Digital, DTS or other multichannel format Dolby or DTS Surround1 Use the (left) and (right) buttons to select the Auto Surround mode.18 AUTOSURR. ON OFF ON(left) button (right) buttonPress the ENTER or (down) button to switch the Ext. In SW Level setting.(Initial)Setting the Ext. In SW LevelSet the playback level of the analog input signal connected to the Ext. In terminal.1 Use the (left) and (right) buttons to select the Ext. In Subwoofer channel Level playback.19 EXT.IN SW +15 +00 +05 +10 +15(left) button (right) buttonPress the ENTER or (down) button if you want to start the settings over from the beginning.(Initial)• Select according to the specifications of the player being used. Also refer to the player’s operating instructions.• +15dB (default) recommended. (0, +5, 10 and +15 can be selected.)After setting up the system1 Press the SYSTEM SETUP button to finish system set up.This completes the system setup operations. Once the system is set up, there is no need to make the settings again unless other componentsor speakers are connected to or the speaker layout is changed.