Denon AVR-2105 Operating Instructions Manual

Also see for AVR-2105: Specifications Operating instructions Service manual Operating instructions Operating instructions

Before setting up the system4 Press the SYSTEM SETUP button to enter the setting.5 Press the ENTER or (down) button to switch to the Auto Setup.*SYSTEM SET UPNOTE:Press the SYSTEM SETUP button again to finish system set up. System set up can be finished at any time. The changes to the settings madeup to that point are entered.NOTE: Please make sure the “AUDIO” position of the slide switchon the remote control unit.3 ON / STANDBY Turn on the power.Press the Power ON/STANDBY switch (button).(Main unit) (Remote control unit)2 ON OFF Press the Power switch (button) .(Main unit)• ¢ ONThe power turns on and indicator is light.Set the power switch to this position to turn the power on and off from the included remote control unit.• £ OFFThe power turns off and indicator is off.In this position, the power cannot be turned on and off from the remote control unit.1 Refer to “CONNECTIONS” (pages 7 to 15) and check that all connections are correct.Auto setupThe Auto Setup function of this unit performs an analysis of the speaker system to permit an appropriate automatic setting.When performing Auto Setup, an optional microphone is required for the setup.2 Measurement and setting detailsq : This sets the speaker connection mode, polarity, and bass reproduction ability.w : This sets the optimum delay time from each speaker corresponding to the listening position.e : This sets the volume that is output from each speaker.NOTE:• A loud test tone is output during the measurement. Please consider this should you be planning night time measurements, and considernot allowing small children into the listening room at this time.21ENGLISH