Denon AVR-2105 Operating Instructions Manual

Also see for AVR-2105: Specifications Operating instructions Service manual Operating instructions Operating instructions

ENGLISH4 Start the measurements.Measurement of each channel is performed as follows.DisplayFL FR C SW2 3SBL SBR1SL SR1 Only the front speakers (A) is measured. Even if thefront speakers (B) is set, the setting automatically switches to the front speakers (A) once measurements are completed.2 Subwoofer speaker is measured twice.3 When “ZONE2” is selected, this is not displayed.After each channel is measured, “Calculating” appears.The display switches to Auto Setup check screen automatically.NOTES:• Measurement is canceled when MASTER VOLUME is operatedwhile the Auto Setup is performed.• Set the volume to halfway and set the crossover frequency tothe maximum or Low pass filter off if your subwoofer speakercan adjust the output volume and the crossover frequency.About automatic retryRemeasurement starts automatically to receive proper result of measurement.Remeasurement is performed to 2 times, and “Retry1” or “Retry2” is displayed on screen duringremeasurement.About the error messageThese error screens will be displayed when performing the measurements of Auto Setup and the automatic measurements can not be completedbecause of the speaker arrangement, measurement environment, or other factors. Please check the following matters, reset the pertinent items,and measure again.When there is too much noise in the room, the speakers may not be detected properly. Should this happen, perform the measurements whenthe noise level is low, or switch off the power of the equipment that is producing the noise for the duration of the measurements.q This screen will be displayed when the speakers required forproducing suitable reproduction have not been detected.• The front L and front R speakers were not properly detected.• Only one channel of the surround speakers was detected.• Sound was output from the R channel when only one surroundback speaker was connected.• The surround back was detected, but the surround speaker wasnot detected.Check that the pertinentspeakers are properlyconnected (see page 15).w This screen will be displayed when the speaker polarity is connectedin reverse.Check the polarity of thepertinent speakers.For some speakers, thescreen below may bedisplayed even thoughthe speakers are properlyconnected.If so, select “Skip0”.e This screen will be displayed when accurate measurementscannot be made due to the input level to the microphone beingtoo high.Set up the speakers sothat their position isfarther away from thelistening position.Lower the volume of thesubwoofer speaker.r This screen will be displayed when the measurement microphoneis not connected, or when all of the speakers have not beendetected.Connect the measurement microphone to the microphoneconnector.Check the speaker connections.23