19ENGLISH Advanced versionSimple version InformationBasic versionConnecting a CD player• You can enjoy CD sound.• Select the connector to use and connect the device.Cables used for connectionsAudio cable (sold separately)Audio cable (White)(Red) RLRLRLRLAUDIOAUDIORLOUTCD playerSet this to change the digital input connector to which the inputsource is assigned.“Input Assign” (vpage 48)in Set as NecessaryConnecting an antennaConnecting an HD Radio receiver• By connecting a HD Radio antenna to this unit, you can receive HDRadio programs.• HD Radio broadcasting currentry is available in the United States andselect other countries.w eqFM outdoorantennaDirection of broadcasting station75 Ω coaxialcableGroundAM outdoorantennaAM loop antenna(for HD Radio broadcasting,supplied)• To prevent interference, installat least 3.3 ft/1 m away from theantenna connected to the thisunit’s other AM tuner terminal.BlackWhiteFM indoorantenna(for HD Radiobroadcasting,supplied)n AM loop antenna assembly1 Put the stand sectionthrough the bottom ofthe loop antenna fromthe rear and bend itforward.StandSquareholeProjectingpartLoopantenna2 Insert the projecting partinto the square hole inthe stand.n Using the AM loop antennaSuspending on a wallSuspend directly on a wall without assembling.Nail, tack, etc.Standing aloneUse the procedure shown left to assemble.NOTE• Do not connect two FM antennas simultaneously.• Even if an external AM antenna is used, do not disconnect the AMloop antenna.• Make sure the AM loop antenna lead terminals do not touch metalparts of the panel.• If the signal has noise interference, connect the ground terminal(GND) to reduce noise.• If you are unable to receive a good broadcast signal, we recommendinstalling an outdoor antenna. For details, inquire at the retail storewhere you purchased the unit.