Denon AVR-3805 Operating Instructions Manual

Also see for AVR-3805: Control protocol Service manual Service manual Operating instructions Operating instructions

Contents

18ENGLISH3 Select the Equalizer curve.CH SELENTERCH SELENTER(Main unit)(Remote controlunit)4 Dislay the parameter screen. 5 Select the speaker channel.CH SELENTER CH SELENTER(Main unit)(Remote controlunit)6 If the check ends, select “Exit” and press the ENTER button. The AutoSetup Menu / Room EQ reappears.CH SELENTERCH SELENTER(Main unit)(Remote controlunit)CH SELENTER CH SELENTER(Main unit)(Remote controlunit)7 Enter the Setting.Select “Exit” and press the ENTER button at the Auto Setup / Room EQMenu screen.The System Setup Menu reappears.CH SELENTER CH SELENTER(Main unit)(Remote controlunit)12Select “Speaker Setup” at the System SetupMenu.Display the Speaker Setup Menu screen.CH SELENTERCH SELENTERCH SELENTERCH SELENTERS p e a k e r S e t u p* S y s t e m S e t u p(Main unit)(Main unit)(Remote controlunit)(Remote controlunit)Setting the Speaker Setup2• Cross over Frequency and Subwoofer Mode Setup is not displayed when not using a subwoofer.• Surround Sp setup is displayed when using both surround speakers A and B.2-1 Setting the type of speakers• The composition of the signals output to each channels and the frequency response are adjustedautomatically according to the combination of speakers actually being used.1 Select “Speaker Config.” at the SpeakerSetup Menu.CH SELENTERCH SELENTERS p e a k e r C o n f i g .* S p e a k e r S e t u p(Main unit)(Remote controlunit)2 Display the speaker configuration screen as below.CH SELENTER CH SELENTER(Main unit)(Remote controlunit)3 Set whether speakers are connected or not and, if so, their size parameters.q Select the speakerCH SELENTERCH SELENTERF r o n t S p : L a r g e* S p e a k e r C o n f i g(Main unit)(Remote controlunit)CH SELENTER CH SELENTER(Main unit)(Remote controlunit)w Select the parameterCenter Sp.Front Sp.SubwooferSurround Sp. ASurround back Sp.Surround Sp. B4 ENTER the setting.The Speaker Setup Menu reappears.CH SELENTER CH SELENTER(Main unit)(Remote controlunit)NOTE:• Select “Large” or “Small” not according to the actual size of the speaker but according to the speaker’scapacity for playing low frequency (bass sound below the frequency set for the Crossover Frequency)signals. If you do not know, try comparing the sound at both settings (setting the volume to a level lowenough so as not to damage the speakers) to determine the proper setting.