Denon AVR-3805 Operating Instructions Manual

Also see for AVR-3805: Control protocol Service manual Service manual Operating instructions Operating instructions

Contents

26ENGLISH4-3 Setting the Auto Surround ModeThe surround mode used at last for the three types of input signals shown below is stored in the memory, andthe signal is automatically played with that surround mode the next time it is input.Note that the surround mode setting is also stored separately for the different input sources.q Analog and PCM 2-channel signalsw 2-channel signals of Dolby Digital, DTS or other multi-channel formate Multi-channel signals of Dolby Digital, DTS or other multi-channel formatDuring playback in the PURE DIRECT mode, the surround mode does not change even if the input signal ischanged.1 Select “Auto Surround Mode” at theAdvanced Playback Menu.CH SELENTERCH SELENTERA u t o S u r r o u n d* A d v a n c e d P l a y(Main unit)(Remote controlunit)2 Press the ENTER button.Display the Auto Surround Mode screen.CH SELENTER CH SELENTER(Main unit)(Remote controlunit)3 Select “ON” if you want to use the autosurround mode, “OFF” if you do not want touse it.CH SELENTER CH SELENTERO N / O F F : O N* A u t o S u r r o u n d(Main unit)(Remote controlunit)4 Enter the setting.The Advanced Playback Menu reappears.CH SELENTER CH SELENTER(Main unit)(Remote controlunit)12Select “Option Setup” at the System SetupMenu.Display the Option Setup Menu Screen.CH SELENTERCH SELENTERCH SELENTERCH SELENTERO p t i o n S e t u p* S y s t e m S e t u p(Main unit)(Main unit)(Remote controlunit)(Remote controlunit)Setting the Option Setup55-1 Setting the Power Amplifier AssignmentMake this setting to switch the power amplifier for the surround back channel to ZONE2 or ZONE3.If ZONE2/3 is selected, the signal that selected at ZONE2/3 is output at “SURR. BACK/MULTI ZONE PREOUT”terminals.1 Select “Power Amp Assign” at the OptionSetup Menu.CH SELENTERCH SELENTERP . A m p A s s i g n* O p t i o n S e t u p(Main unit)(Remote controlunit)2 Press the ENTER button.Display the Power Amp Assign screen.CH SELENTER CH SELENTER(Main unit)(Remote controlunit)3 Select “Surround Back” to use as thesurround back channel, “Zone2” to use asZone2 out, Zone3 to use as Zone3 out.CH SELENTER CH SELENTER S . B a c k* P . A m p A s s i g n(Main unit)(Remote controlunit)When “Surround Back” isselectedWhen “Zone2” isselectedWhen “Zone3” isselected