Speaker connectionHere we connect the speakers in the room to this unit.This section explains how to connect them using typical examples.NOTE0 Disconnect this unit’s power plug from the power outlet before connecting thespeakers. Also, turn off the subwoofer.0 Connect so that the speaker cable core wires do not protrude from the speakerterminal. The protection circuit may be activated if the core wires touch the rearpanel or if the + and - sides touch each other. (“Protection circuit” (v p. 232))0 Never touch the speaker terminals while the power cord is connected. Doing socould result in electric shock. When the “Setup Assistant” (page 8 in the separate“Quick Start Guide”) is running, follow the instructions in the “Setup Assistant”screen for making connections. (Power is not supplied to the speaker terminalswhile the “Setup Assistant” is running.)0 Use speakers with an impedance of 4 – 16 Ω/ohms.NOTE0 Carry out the following settings when using a speaker with an impedance of 4 – 6Ω/ohms.1. Press and hold the main unit’s TUNER PRESET CH + and TUNE + for at least3 seconds.“V.Format:< NTSC>” appears on the display.2. Press DIMMER on the main unit twice.“Sp.Imp.:<8ohms>” appears on the display.3. Press TUNER PRESET CH + or TUNER PRESET CH － on the main unit toselect the impedance.6 Ω: 6 Ω/ohms to 8 Ω/ohms is selected even if it is for one speaker with aconnected impedance.4 Ω: 4 Ω/ohms to 8 Ω/ohms is selected even if it is for one speaker with aconnected impedance.4. Press the main unit’s STATUS to complete the setting.Contents Connections Playback Settings Tips Appendix28Front panel Display Rear panel Remote Index
