Denon D-107 Operating Instructions Manual

Also see for D-107: Brochure Service manual Service manual

Contents

21ENGLISH12 PLAYING CDs(1) Playing CDsON / STANDBYFUNCTION 2 / BAND VOLUMEPERSONAL AUDIO SYSTEM / CD RECEIVER1CLEAR1 2 354 67 8 9+1010TONE/SDBREPEATCALLPROG /DIRECTRANDOMENTERDISPLAY MENUSLEEPFOLDERTITLETIMEPOWEROPEN / CLOSESTOP/BAND PLAY/PAUSEVOLUMEPRESET5 1322 3NOTES:• “No Disc” is displayed when no disc is loadedor the disc is loaded inside out.• According to recording quality, some CD-R/RWcannot be played.• The all-track/1-track remaining time is notdisplayed if the information on the disc cannotbe read properly due to scratches or dirt. In thiscase, some time may be required for cueing.• When the 5 or 1/3 button is pressed while inthe standby mode, the power turns on and thedisc loading/unloading operation or the playbackoperation is performed.• Do not use CDs that have the exposedadhesive or marks remaining from cellophanetape, rental CD labels, or other sources. Use ofCDs in this condition will result in difficulty inremoving the CD or could cause breakdown.2 Load a CD in thedisc door.(See page 12.)1 Press the buttonto turn the poweron.POWER(RC-909)3 Press the 1/3button to startplayback.PLAY/PAUSE(RC-909)(Main unit)OPEN / CLOSE5(RC-909)(Main unit)During playback,press the 2/BANDbutton.STOP/BAND(RC-909)2 / BAND(Main unit)(2) Stopping playbackON / STANDBYFUNCTION 2 / BAND VOLUMEPERSONAL AUDIO SYSTEM / CD RECEIVER1TONE/SDB ENTERDISPLAY MENUSTOP/BAND PLAY/PAUSEVOLUMEFUNCTIONMUTEPRESET+-1111 ADJUSTING THE TONETONE/SDB ENTERDISPLAY MENUSLEEPFOLDERTITLETIMESTOP/BAND PLAY/PAUSEVOLUMEFUNCTIONMUTEPRESET+-211 Press the TONE/SDB button to adjustthe tone and display the mode.Each time you press thisbutton, the display changes asfollows:TONE/SDB23 The adjusted value is displayed forapproximately 5 seconds, after whichthe display returns to normal.Treble 0dBSDB OffBass 0dB Mid 0dBPress the +/− buttons to adjust thelevel.• The level can be adjusted inthe range of −10 to 0 to +10in steps of 2.• The “TONE” indicator isdisplayed when the level isset at anything other than0dB.To adjust the bass, mid-range ortreblePRESET+-Press the +/− buttons toselect “On” or “Off”.• When set to “On”, the“SDB” indicator lights.To adjust the SDBPRESET+-2 The bass (BASS), mid-range (MID), treble (TREBLE)super dynamic bass (SDB) can each be adjusted toachieve the desired tone.2 The volume of the bass sound is increasedaccording to the overall volume and theabove BASS adjustment.ON / STANDBY(Main unit)Lit greenAbout installation2 About speaker installation• Set the speakers sufficiently apart from eachother to achieve a suitable stereo effect (senseof expansion).• It is recommended that the speakers be placedat least 7 cm from the D-107. (See the diagrambelow.)The quality of the sound produced from the speakersdepends on the size of the room, the type of room(Japanese style or western style) and how thespeakers are mounted. Adjust the sound to suit yourtastes.2 About subwoofer installation• The set’s sound balance is set assuming thesubwoofer is installed on the floor.• If the subwoofer is placed against a wall, thebass sound may seem amplified due to thesound reflecting off the wall. Adjust the basssound (BASS) to suit your tastes.See “Adjusting the tone” for instructions onadjusting the bass sound (BASS).7 cm or greaterOn floor2 About main unit installationWhen installing on a desk or table, mount theincluded stand and set the unit vertically. (Seepage 7.)The disc may fall out of the disc holder if the unitis set in any direction other than vertically. (Seepage 12.)