Denon DN-500CB User Manual

Contents

6Rear Panel1. Outputs (unbalanced RCA): These outputs send the audio signals from a CD, USB device (mass storage class),and device connected to the Aux In. Use RCA cables to connect these outputs to external speakers, soundsystem, etc. See Setup for more information.2. Outputs (balanced XLR): These outputs send the audio signals from a CD, USB device (mass storage class),and device connected to the Aux In. Use XLR cables to connect these outputs to external speakers, soundsystem, etc. See Setup for more information.3. AC In: Use the included power cable to connect this input to a power outlet. See Setup for more information.4. Bluetooth Receiver: This is the built-in antenna used to receive a signal from a Bluetooth device.5. Remote Input: This input lets you connect a host device (usually a computer) to DN-500CB. You can use thehost device to control DN-500CB via commands sent from it (using RS-232C serial communication).Note: Go to denonpro.com to access the serial protocol guide for more information.6. Operation Switch: For standard playback, leave this switch at the “Normal” position. If updating the unit, set thisswitch to the “Update” position.SetupImportant: Connect all cables securely and properly (with stereo cables: left with left, right with right), and do notbundle them with the power cable.1. Use XLR cables or a stereo RCA cable to connect the Outputs (balanced or unbalanced) to the analog inputs ofyour external receiver, amp, powered monitors, etc.2. After completing all the connections, use the included power cable to connect the AC In to a power outlet.Example:Receiver, amp, etc. PowerPowered MonitorsBLUETOOTH RECEIVERZONE 2SOURCE ZONE 3 ZONE 3SOURCE STATUS DIMMERVIDEOAUX 1SETUP MICINTEGRATED NETWORK AV RECEIVERS SE ER IAVR-X4000IN-CommandL - AUDIO - R1 CBL/SAT 3 GAME 4 NETWORKQUICK SELECT2 Blu-rayPHONES BACKENTERINFOSETUPZONE 2SOURCE SELECTMASTER VOLUMEON/OFFAUX 1HDMI 7 5V/1AON/OFF OPTIONBLUETOOTH RECEIVER1 2 3564