8Battery UsageImportant: Before using the remote control for the first time, pull the insulation sheet out from the batterycompartment.To replace the battery:1. On the back of the remote control, put a pin into thedoor release hole and then slide the door releaseopen.2. Pull out the old lithium battery from the battery caseand insert a new one. Place the battery so that thepositive (+) side faces upward.3. Place the battery case carefully into the compartmentso the edges are in the grooves and then slide thebattery case to its original position.Important: Misuse of the lithium battery can result in heat build-up, ignition, or rupture. Bear in mind thefollowing points when using or replacing batteries:• The supplied battery is for testing the functionality of the remote controller.• Use a 3V CR2032 lithium battery.• Never recharge the battery. Do not handle the battery roughly or disassemble the battery.• When replacing the battery, place it with its polarities (+ and -) facing the correct directions.• Do not leave the battery in a place subject to high temperature or direct sunlight.• Keep the battery in a place beyond the reach of infants or children. If a battery is swallowed, consult aphysician immediately.• If electrolyte has leaked, discard the battery immediately. Be careful when handling it as the electrolytecan burn your skin or clothes. If the electrolyte touches your skin or clothes, immediately wash withtap water and consult a physician.• Before discarding a battery, insulate it with tape, etc. and dispose of it in a place without fire, byfollowing the directions or regulations laid down by the local authorities in the area of its disposal.Operating RangePoint the remote control at the IR sensor when operating it.Note: If the remote control sensor is exposed to direct sunlight, strong artificial light (like from aninterverter-type fluorescent lamp), or infrared light, the unit or remote control may not function properly.DOOR RELEASEOPENDOOR RELEASEOPEN+DOOR RELEASE1 2 3