Denon DN-700AV User Manual

Also see for DN-700AV: User guide

Contents

47 108 9 11 12 1314 15 1617 186451237101089111112126451 231313 1414 151516161717181819192020Rear Panel1. Digital Inputs: Connect devices with coaxial and optical audio inputs here.2. Network Connector: This connector is used to connect the unit to a LAN (local area network). The port isused to remotely control the unit, to stream audio from a media server, or to connect to Internet radio.3. Composite Video Inputs: Connect video outputs from a composite video device here.4. HDMI Inputs: Use these 5 HDMI inputs to directly route the video and audio to the HDMI output.5. HDMI Out: Connect this HDMI output to a TV or monitor.6. Analog Audio Inputs: Connect the audio output of your sound sources here.7. Serial Port: This input lets you connect a host device (usually a computer) to DN-700AV. You can use thehost device to control DN-700AV via commands sent from it (using RS-232C serial communication).8. Composite Video Output: Connect this video output to the video input of another video source.9. Component Video Inputs: Connect the video inputs to the video output of another video source.10. Component Video Outputs: Connect the video outputs to the video input of another video source.11. FM Tuner Antenna: Connect the included antenna here to get reception for FM radio sources.12. Stereo XLR Input: Connect these balanced XLR inputs to the output of a preamp or mixer.13. Input Level Setting Switch: Adjust this to switch the audio input level to -10 dBv or +4 dBu.14. Preamp Outputs: Connect these individual surround channel XLR outputs to the input of a mixer or preamp.15. Preamp Output Level: Adjust this to switch the surround channel XLR output level to -10 dBv or +4 dBu.16. Power Input: Connect the included power cable here.17. Zone 2 Outputs: Send the audio signal from the L/R and subwoofer output to another location.18. Euroblock Outputs: Use these Euroblock outputs to send individual channels of the surround mix of theaudio to a speaker setup (75W per channel).19. Bluetooth Antenna: The integrated antenna is used for Bluetooth reception.20. Firmware Update: The “Service/Normal” switch is used to set the mode for the USB connection for thefirmware upgrade. For normal operation, this switch should be left in the Normal position.