Denon DN-MCX8000 User Manual

1154. Crates/Playlists: While using Serato DJ, press this to show the different panels. Press andhold Shift and then press this button to change the view layout.While using Engine, press this to view your crates. Press and hold Shift and then pressthis button to view your playlists.Important: We recommend using the Engine software on your computer to configure themusic library on your USB flash drive before connecting it to MCX8000. Analyzing yourmusic library in Engine will enable you to use hot cue points, crates, and playlists as well asview color-coded waveforms. See Using Engine > Getting Started to learn how to do this.55. Load Prep / Open Prep: Press this button to load the currently selected track to thePrepare Crate (Serato DJ) or Prepare list (Engine).While using Serato DJ, press and hold Shift and then press this button to select thePrepare Crate (Serato DJ) or Prepare list (Engine).Tip: Press and hold Shift and press this button to remove a track from the Prepare Crate(Serato DJ) or Prepare list (Engine).56. Needle Drop Strip: The length of this strip represents the length of the entire track. Placeyour finger on a point along this sensor to jump to that point in the track.Important: During playback, place the palm of your hand on the platter (while usingEngine) or press and hold Shift (while using Engine or Serato DJ) while touching theNeedle Drop strip to use it. This feature is to prevent the track from skipping to anotherlocation if you accidentally touch it.57. Zoom In/Out: Press this button to zoom into the waveform in the display.Press and hold Shift, and then press this button to zoom out of the waveform in the display.58. Single/Cont / Load Lock: Press this button to switch between Single Mode (tracks willplay one at a time) or Continuous Mode (once a track is done, the next track in the playlist,crate, or folder will start playing).While using Engine, press and hold Shift and then press this button to enable or disableLoad Lock. When enabled, the deck will not load a track during playback (to prevent youfrom unintentionally interrupting the current track). See Using Engine > Playing Tracks tolearn more.59. Time: Press this button to switch between showing the Time Remaining and Time Elapsed.60. FX Level: Turn this knob to adjust the level of the corresponding effect. The FX On buttonunder the knob must be lit for this knob to function.While using Serato DJ, press and hold Shift and then turn this knob to scroll through thelist of effects. See Using Serato DJ > Playing Tracks > Effects to learn more.While using Engine, the effects are limited to Echo, Phaser, and Noise. See Using Engine> Playing Tracks > Effects to learn more.61. FX On / Select: Press this button to turn the corresponding effect on or off.Press and hold Shift and then press this button to select an effect in Serato DJ. See UsingSerato DJ > Playing Tracks > Effects to learn more.While using Engine, the effects are limited to Echo, Phaser, and Noise. See Using Engine> Playing Tracks > Effects to learn more.62. FX Beats: Turn this knob to adjust the rate of time-based effects on that deck.Press this knob to set the Effect Beats Multiplier to 1 beat.63. FX Tap: Tap this button repeatedly at the desired tempo to set the rate of the effects’ low-frequency oscillators (LFOs).Press and hold this button to reset the rate to the Deck’s BPM.