Connections Connections8ENGLISHConnecting a tape deck, CD recorder or MD recorderRLAUDIO INRLAUDIO OUTRLRLARLRLATape deck/CD recorder/MD recorder• The phono input can accept signals from moving magnet (MM) and high output moving coil (MC) phonocartridges. If your turntable is equipped with a low output MC cartridge, you will need to use a separateMC head amplifier or step-up MC transformer.NOTE:• If humming or other noise is generated when the ground wire is connected to the SIGNAL GNDterminal, disconnect the ground wire.Connecting a VCRRLAUDIO OUTRLAUDIO INVIDEOINVIDEOOUTRLRLDDAARLRLVideo deckAn F-type FM antenna cable plug can be connected directly.Connecting the antenna terminalsDirection of broadcastingstation75 Ω/ohms CoaxialcableFM antennaFM indoor antenna (Supplied)AM loop antenna(Supplied)AM outdoor antennaGround142 3¢ AM loop antenna assemblyConnect to the AMantenna terminals.Remove the vinyl tieand take out theconnection line.Bend in the reversedirection.a. With the antenna ontop any stablesurface.b. With the antennaattached to a wall.MountInstallation hole Mount on wall, etc.NOTE:• Do not connect two FM antennassimultaneously.• Even if an external AM antenna is used, donot disconnect the AM loop antenna.• Make sure the AM loop antenna leadterminals do not touch metal parts of thepanel.Connection of AM antennas1. Push the lever.2. Insert the conductor.3. Return the lever.ENGLISHNote to CATV system installer:This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NECwhich provides guidelines for proper grounding and, in particular, specifies that the cable ground shallbe connected to the grounding system of the building, as close to the point of cable entry as practical.