22ENGLISHOperating DENON audio componentsSet [MODE SELECTOR 1] to “A” or “B”.1Operate the audio component.For details, refer to the component’s operating instructions.While this remote control is compatible with a wide range ofinfrared controlled components, it may be the case that somecomponent models cannot be operated with this remote control.3Set [MODE SELECTOR 2] to the position for thecomponent to be operated.2Setting the preset memory functionSet [MODE SELECTOR 2] to the component to beregistered.2Set [MODE SELECTOR 1] to “A” or “B”.Set to the A side for the CD/iPod, TV, DBS/CABLE or DVDposition, and to the B side for the CD-R/TAPE or VCR position.1• DENON and other makes of components can be operated by settingthe preset memory.• This remote control unit can be used to operate components ofother manufacturers without using the learning function byregistering the manufacturer of the component as shown in the listof preset codes ( End of this manual).• Operation is not possible for some models.Press [ZONE2 OFF] and [ZONE3 ON] at the same time.• The indicator starts flashing.3Operating the remote control unitTo store the codes of another component in thememory, repeat steps 1 to 4.5• The signals for the pressed buttons are emitted while setting thepreset memory. To avoid accidental operation, cover the remotecontrol unit’s transmitting window while setting the preset memory.• Depending on the model and year of manufacture, this functioncannot be used for some models, even if they are of makes listed inthe list of preset codes.• Some manufacturers use more than one type of remote controlcode. Refer to the included list of preset codes to change thenumber and verify correct operation.• The preset memory can be set for one component only among thefollowing: CD/iPod, DBS/CABLE and CD-R/TAPE.Setting the punch through functionSet [MODE SELECTOR 1] to “A”.1Press [A] and [D] at the same time.• The indicator starts flashing.3Set [MODE SELECTOR 2] to the component to beregistered (TV or DBS/CABLE).2“Punch Through” is a function allowing you to operate 1, 2, 0, 3,6, 7, 8 and 9 on CD, DVD/VDP, TAPE/CD-R/MD or VCRcomponents when in the TV or DBS/CABLE mode. By default, nothingis set.Input the number of the component you want to set.4 No.CD 1DVD/VDP 2TAPE/CD-R/MD 3VCR 4No setting 0Operating a component stored in the presetmemoryOperate the component.For details, refer to the component’s operating instructions.Some models cannot be operated with this remote control unit.Set [MODE SELECTOR 1] to “A” or “B”.Set to the A side for the CD/iPod, TV, DBS/CABLE or DVDposition, and to the B side for the CD-R/TAPE or VCR position.13Set [MODE SELECTOR 2] to the component you wantto operate.2Referring to the included list of preset codes, press[NUMBER] to input the preset code (a 3-digit number)for the manufacturer of the component whose signalsyou want to store in the memory.4ENGLISH