Denon DVD-9000 Operating Instructions Manual

Also see for DVD-9000: Setup guide Specifications Specifications Operating lnstructions Service manual

ENGLISH14(4) Connecting a basic 5.1-channel surround systemAnalog 5.1-channel audio signals can be output from the DVD-9000.The multichannel audio signals recorded in packed PCM can be played when an AV amplifier equipped with analog 5.1-channel audioinputs is connected.DVD-9000Front speaker (left)Surround speaker (left)Center speakerAV amplifier with 5.1-channelinpur terminalsFront speaker (right)SubwooferSurround speaker (right)To power outletFRONTSUBWOOFERSURROUNDCENTERNOTES:• For multi-channel connections, set “AUDIO CHANNEL” under “AUDIO SETUP” at “SETUP” to “MULTI CHANNEL” and make the“SPEAKER CONFIGURATION”, “CHANNEL LEVEL” and “DELAY TIME” settings.• Set “LPCM (44.1 kHz/48 kHz)” under “AUDIO SETUP” at “SETUP” to “OFF”. (See page 32.)(If set to “ON”, analog audio signals converted to 48 kHz will be output for linear PCM or packed PCM sources.)• When playing DVDs that are not copyright-protected and the unit is set to output digital and analog audio signals simultaneously, for somediscs only the signals below 96 kHz for the front two channels will be output for the analog part.When playing DVDs that are not copyright-protected, set “DIGITAL OUTPUT” at “PURE DIRECT MODE” to “OFF”. (See page 54.)• With the DVD-9000, we recommend turning the digital output off and only outputting analog signals in order to keep interference fromthe digital output circuitry to the minimum and allow you to enjoy high bit, high sampling frequency, high quality multi-channel sound.