ENGLISH4610 ADJUSTING THE PICTURE QUALITY13Use the 0 and 1 cursor buttons to select thepicture memory, then press the ENTER button.• The display switches as follows:STD (STANDARD) ´ M1 (MEMORY 1) ´ M2 ´M3 ´ M4 ´ M5STD (Factory default)When this is selected, both the picture quality andfunction are reset to factory setting.M1 to M5Picture quality settings you have adjusted can bestored here.Select the item to change using 0 and 1 buttons.ADJUST MODE• The contrast , brightness , sharpness and color(HUE) can be adjusted.• Perform steps 4 and 5 to adjust the picture quality(ADJUST MODE).GAMMA• Select this if dark portions of the picture are toodark or bright portions are too bright.(This does not affect Interlaced images.)• Perform steps 7 and 8 to adjust the gammacorrection (GAMMA).DISPLAY SUBTITLE ANGLESKIP SLOW / SEARCHMENURETURNPURE DIRECTMEMORYPICTUREADJUST DIMMER ZOOMPROG/DIRCLEARCALLMARKER1 2 34 5 67 8 90 SEARCH MODEAUDIOSTOP PLAYSTILL / PAUSETOP MENU10ENTER2, 6, 92, 3, 4, 5, 7, 81P I C TURE MODESTD M1 M2 M3 M4 M5ENTERRemote control unitRemote control unitMEMORY 1 GAMMA0 0 0 0Remote control unitPress the PICTURE ADJUST button during playback.PICTUREADJUSTRemote control unit24Press the ª cursor button to select the adjust mode,then use the 0 and 1 cursor buttons to select theimage quality adjustment item.CONTRAST (-6 ~ +6)Adjusts the contrast of the image.BRIGHTNESS (0 ~ +12)Adjusts the picture’s brightness.SHARPNESS (-6 ~ +6)Adjusts the sharpness of the picture.HUE (-6 ~ +6)Adjusts the balance of the green and red. (This doesnot affect Progressive Scan images.)MEMORY 1 GAMMACONTRAST0 0 0 0Remote control unitRemote control unit