Operation mode select switchInput select switchHIGH--AUDIQ--Bi-wiring connectionWhen using speakers that have input terminals for both woofer units and tweeter units, this connectionallows for the same signal to be output from each unit.With this connection the interference between signals for the woofer unit and tweeter unit is low so thatyou can enjoy high quality sound in playback..~[.Ij.The Operation mode select switch and Input select switch must be set before turning the power on.Settings which are changed after powering on will not be registered. In such cases, the power should beswitched off and on again.'~[e$,.When using Bi-Wiring connection use 4 - 16 OIohms speakers for the impedance.Operation mode select switchInput select switche Ej)"@"o~"@"~D·-~~e Ej)Settings and ConnectionsSet the rear panel "Operation mode select switch" and "Input select switch" according to theconnection method.--AUDIO--PRE PRE~ ;SPEAKER B II SPEAKER AConnection for signal input to each channel to be output from the channel's speaker terminal.• Set each switch as shown below.CD Set the Operation mode select switch to "'NORMAL"' (GT'page 6).@ Set the Input select switch according to the input (GT'page 6).. For RCA input Set to "'RCA"'.. For XLR input······· Set to "'XLR"'.I· Normal Connections·Example: Normal connection to the 0 channel*Setup each channel 1111- •.0 -111) using the same steps.• ¢t,jj."The same signal is output to speakers A and B.• Please use the following speaker impedance.. When using only speaker A or B ····························4 - 16 O/ohms. When using speakers A and B at the same time ···8 - 16 O!ohms9