Denon POA-A1HDCI Owner's Manual

Also see for POA-A1HDCI: Product review Owner's manual Brochure & specs Command list Service manual

Contents

Denon POA-A1HDCI Owner's Manual Manual pdf 13 page image

--AUDIO--PRE PREOUT OUT.~ GHIGHExample: Bi·Amp connection using. and m channels'* Setup each pair channel using the same steps.When using speakers that have input terminals for both woofer units and tweeter units. thisconnection outputs one input signal from the two amps on the main unit to each of these units.With this connection the interference between signals for the woofer unit and tweeter unit iseliminated so that you can enjoy high quality sound in playback.• Bi-Amp output is setup using the following combination of channels. The input terminals to be used areas follows.• and minput terminal: mchannelsiii and. input terminal: • channelsm and III input terminal: III channelsIII and. input terminal: III channelsIII and IfJ input terminal: III channels• Set each switch as shown below.CD Set the Operation mode select switch to "Bi-AMP" ((J"page 6)@ Set the Input select switch according to the input ((J"page 6) .. For RCA input Set to "RCA'· .. For XLR input· Set to "XLR".•.....~"'[·!"l'i""j"'l·..The input terminal (channel. in case of • and m) that is not used for this setting becomes invalidregardless of the status of Input select switch.Operation mode select switch Input select switch-N·U •• The same signal is output to channel. and channel m.• No signal is output from the speaker B terminal.• Use speakers with an impedance of 4 - 16 O/ohms.10