Getting Started Connections Setup Playback Setting the Timer Other Functions TroubleshootingENGLISHTroubleshootingSymptom Cause Countermeasure PageBuzzing noise inFM broadcasts.• The antenna cable is not properlyconnected.• Noise interference from a nearbyelectronic device equipped witha microprocessor, or the radiobroadcast signal is weak.• Connect the antenna properly.• Reposition the equipment or thepositions or directions of theconnection cables, antenna, etc.• Connect an outdoor antenna.10––Hissing or buzzingnoise is heard inAM broadcasts.• Noise interference from anearby monitor, etc., or thereis interference in the broadcastsignal.• Turn off the monitor.• Change the position or directionof the AM loop antenna.• Connect an outdoor antenna.–––Humming noiseis heard in AMbroadcasts.• There is interference from currentin power cords.• Connect an outdoor antenna. –GTunerHSymptom Cause Countermeasure PageWhen playingrecords, a wailingnoise (howling) isproduced whenthe volume israised.• The player and speakers are tooclose together.• The floor is soft and vibrateseasily.• Move the player and speakers asfar apart as possible.• Use cushions or spikes to absorbthe vibrations of the speakersbeing conveyed from the floor.––GRecord PlayerHSymptom Cause Countermeasure PageiPod cannot beplayed.• Device you want to play and setinput source do not match.• Cable is not properly connected.• Control dock for iPod’s ACadapter is not connected topower outlet.• Select an appropriate inputsource.• Reconnect.• Plug the control dock for iPod’sAC adapter into a power outlet.189–GiPodHSymptom Cause Countermeasure PageSet does not workproperly whenremote controlunit operated.• Batteries are worn.• You are operating outside of thespecified range.• Obstacle between main unit andremote control unit.• The batteries are not inserted inthe proper direction, as indicatedby the polarity marks in thebattery compartment.• The set’s remote control sensoris exposed to strong light (directsunlight, inverter type fluorescentbulb light, etc.).• Replace with new batteries.• Operate within the specifiedrange.• Remove the obstacle.• Insert the batteries in theproper direction, following thepolarity marks in the batterycompartment.• Move the set to a place in whichthe remote control sensor willnot be exposed to strong light.44444GRemote Control UnitHSpecificationsn Receiver sectionRated output: 2-channel driving37.5 W + 37.5 W (8 Ω/ohms, DIN, 1 kHz, T.H.D. 0.7 %)75 W + 75 W (4 Ω/ohms, DIN, 1 kHz, T.H.D. 0.7 %)High frequency distortion: 0.05 % (Rated output: –3 dB), 8 Ω/ohms, 1 kHzOutput terminals: Speaker 4 ~ 16 Ω/ohmsSuited for headphones/stereo headphonesEqualizer amplifier output(REC OUT terminals): Rated output : 150 mVInput sensitivity / Input impedance: PHONO (MM) : 2.5 mV / 47 kΩ/kohmsPHONO (MC) : 0.2 mV / 100 Ω/ohmsCD, LINE1, LINE2 : 130 mV / 47 kΩ/kohmsRIAA deviation: PHONO (MM) : 20 Hz ~ 20 kHz ±0.5 dBPHONO (MC) : 30 Hz ~ 20 kHz ±0.5 dBReception frequency range: FM : 87.5 MHz ~ 107.9 MHz AM : 520 kHz ~ 1710 kHzReception sensitivity: FM : 1.5 μV / 75 Ω/ohms AM : 20 μVFM channel separation: 35 dB (1 kHz)FM S/N ratio: Monaural : 74 dB Stereo : 70 dBFM harmonic distortion: Monaural : 0.3 % Stereo : 0.4 %S/N ratio: PHONO (MM) : 84 dB(With input terminals short-circuited, 5 mV input signal)PHONO (MC) : 70 dB(With input terminals short-circuited, 0.5 mV input signal)(A-weighted network): LINE1, LINE2 : 95 dB (input terminals short-circuited)Tone control: BASS : 100 Hz ± 8 dBTREBLE : 10 kHz ± 8 dBFrequency response: 10 Hz ~ 40 kHz (+0.5 dB, –3 dB) (INPUT: LINE1, PURE DIRECT: ON)n Clock/Timer sectionClock type: Power line frequency synchronized method (Within ±60 seconds per month)Timer: Everyday timer / Once timer : One system eachSleep timer : Max. 90 minutesnCD section[Super Audio CD] [CD]• Analog outputSignal type: 1-bit DSD 16-bit linear PCMSampling frequency: 2.822 MHz 44.1 kHzUsable discs: Super Audio CD Compact Disc• Digital outputOptical: – –15 ~ –21 dBmEmission wavelength: – 660 nmn GeneralPower supply: AC 120 V, 60 HzPower consumption: 50 W0.3 W (Standby)Maximum external dimensions: 300 (W) x 110 (H) x 341 (D) mmWeight: 8.0 kgn Remote control unit (RC-1109)Remote control method: Infrared pulse methodBatteries: R03/AAA Type (two batteries)Maximum external dimensions: 44 (W) x 233 (H) x 22 (D) mmWeight: 165 g (including batteries)z For purposes of improvement, specifications and design are subject to change without notice.Specifications