q Insert the included hexagonal wrench into the holeat the side of the connector’s “+” side. (Arrow A)w Turn the hexagonal wrench in the direction ofarrow B to loosen the cable.e Pull out the old cable. Be careful not to leave anybroken wire parts inside the connector. (Arrow C)r Peel off the cable’s sheath and insert the newcable with the copper colored core wire twistedtightly together into the connector. (Arrow D)t Turn the hexagonal wrench in the direction ofArrow E and tighten securely so that the cable cannot be pulled out. Be sure to connect bothsides of the cable to the connectors with the proper polarities.If the polarities are inverted, the phase may be off and the bass sound may be missing, resultingin an unnatural sound.16ENGLISHENGLISHConnecting Other Sources Connecting Other SourcesCOMPONENT VIDEO INYPB/CBPR /CRMonitor TVDF• Set the “TV TYPE” in “VIDEO SETUP” in “SETUP” in “HELP” to comply with your TV’s videoformat. When the TV is NTSC formatted set to NTSC.• When the PROGRESSIVE/INTERLACED switch on the ADV-S101’s rear panel is set to“PROGRESSIVE”, no video signals are output from the VIDEO OUT or S-VIDEO OUT terminals.Set the PROGRESSIVE/INTERLACED switch on the ADV-S101’s rear panel to “INTERLACED”, if youwant to use the VIDEO OUT or S-VIDEO OUT signals. ( page 11, 15).Connecting a component connections(Better than S-Video picture quality)• For the component output only, it is possible to switch between interlace image output andprogressive image output. It is not possible to specify progressive image output for the Videooutput connectors or S-Video output connector.PROGRESSIVE:Select this when using the ADV-S101 connected to a progressive type TV.INTERLACED:Select this when using the ADV-S101 connected to an interlace type TV.2 To switch from interlace to progressive• Turn off the power before changing the switch.• Choose settings according to the TV to be connected.• Set the PROGRESSIVE/INTERLACED switch on the ADV-S101’s rear panel toselect the type of the TV.To change the speaker cableConnecting the antenna terminals• An F-type FM antenna cable plug can be connected directly.• If the FM antenna cable’s plug is not of the F-type, connect using the F-type antenna adapter(Option).Direction ofbroadcasting station75 Ω/ohmsCOAXIAL cableFM antenna AM loop antenna(Supplied)AM outdoorantennaGroundFM antennaadapter(Option)C DRefer to the procedure below if you want to switch to a different speaker cable. This exampledescribes how to mount the “+” side cable to the connector. Mount the “–“ side cable in the sameway.AEBNOTE:• Do not connect two FM antennassimultaneously.• Even if an external AM antenna is used, donot disconnect the AM loop antenna.• Make sure AM loop antenna lead terminalsdo not touch metal parts of the panel.PROGRESSIVE/INTERLACEDBlack White