Denver Instrument PK-Series Operation Manual

Contents

Denver Instrument PK-Series Operation Manual Manual pdf 14 page image

User Configurable BalanceParametersChanging configurable internal balance parameters requires accessing thebalance internal menu system via the keypad. Navigating the menu systemis performed as follows:1. To gain access to the balance internal menu system, start with the bal-ance turned off. Briefly press the "ON/MEMORY" key and immediately(and briefly) press the "TARE/PRINT" key while all LCD segments are illu-minated. You should see a "1" toward the left side of the LCD. This is the"left" segment value.2. To increment the displayed digit within any segment, briefly press the"TARE/PRINT" key repeatedly until you reach your target value.3. To switch from one code segment to another, IE. from the left to centerdigit, center to right digit, or right to left digit, briefly press the"CAL/MODE" key. Increment each digit segment by the methodexplained in #2, above.4. When switching from the center to right segment, the number displayedis the setting that is currently selected - marked by a small right facingarrow that points to the “g” indicator on the lower right side of thedisplay.5. To select a new value, increment the third segment (#2) until you reachthe new desired value. To lock in this new value, press and hold the"CAL/MODE" key until the small right facing arrow appears andpoints to the “g” indicator on the lower right side of the display.6. If you need to move on and change other internal values, do so byrepeating steps 2-5 above.7. To finalize and save all revised parameter settings, press and hold the"TARE/PRINT" key until the balance resets. All your new settings arenow balance defaults at startup.To reset the balance to all its factory default parameters, specifythe menu code "9 - 1" and invoke step #7, above.Memo:Note:10