www.desatech.com 119143-01A4Air ForCombustionAir ForHeatingUNPACkINg1. Remove all packing items applied toheater for shipment. Keep plastic covercap (attached to heater inlet connector andhose/regulator assembly) for storage.. Remove all items from carton.3. Check all items for shipping damage. Ifheater is damaged, promptly inform dealerwhere you bought heater.ASSEMBLyIMPORTANT: Do not use this product withoutleg and foot assembly.handleAttach handle to control box with screws(long) as shown in Figure 3.Plastic Foot and Leg Extensions1. Insert leg extensions into outlet end capuntil small hole lines up with larger hole,visible from inside of outlet end cap (seeFigure 3). Fasten leg extensions withprovided screws (short).. Insert plastic foot ends into each leg ex-tension and set heater to desired angle.CoolAir In(Back)MotorHose/RegulatorAssemblySpark IgnitorCombustionChamberFigure 4 - Cross Section Operational ViewFanCleanHeatedAir Out(Front)THEORy OF OPERATIONThe Fuel System: The hose/regulator assembly attaches to the propane gas supply. For55/85/15 models, the propane gas moves through the automatic control valve, burn rateadjustment valve and out the injector. For 170 models, the propane gas moves through thesolenoid valve, burn rate adjustment valve and out the injector.The air System: The motor turns the fan. The fan pushes air into and around the combustionchamber. This air is heated and provides a stream of clean, hot air.The ignition System: For 55/85/15 models the high voltage ignitor sends voltage to the sparkignitor. For 170 models direct spark ignitor sends voltage to the spark ignitor. The spark ignitorignites the fuel and air mixture.The Safety Control System: This system causes the heater to shut down if the flame goesout. The motor will continue to run, but no heat is produced.Figure 3 - Handle and Foot AssemblySolenoid Valve(170 models only)PowerCordInjectorThermalLimit SwitchSmall post screws on plastic foot will snapinto holes in leg extensions.Cord CleatsInstall cord cleats on side of end caps as shownin Figure 3 with screws provided (short).OutletEnd Cap HandleLeg ExtensionPlastic FootSmallPostHigh Voltage Ignitor (55/85/15Models) or DSI (170 Models)Leg ExtensionFasteningScrew (short)Automatic Control Valve(55/85/15 models only)CordCleatLong screwsShortScrew