Desa Comfort Glow LFP33PR Owner's Operation And Installation Manual

Contents

14104888UNVENTED PROPANE/LP GAS FIREPLACELFP33PRINSTALLATIONContinuedOPTIONAL WIRELESS HAND-HELD REMOTE CONTROLACCESSORY RM4Installing Remote Receiver Unit1. Disconnect switch wires from the con-trol valve.2. Remove screws and nuts attachingswitchplate. Save screws and nuts toattach receiver.3. Remove switch plate (see Figure 27).Discard after removing.4. Install remote receiver unit onto remoteswitch bracket using screws and nutsremoved in step 2. See Figure 285. Route wires through hole in the upperportion of the switch plate (Figure 28).Connect wires as shown in Figure 29.(Black and blue wires are not used forthis application.)Figure 27 - Switch Plate and WiringHarnessFigure 30 - Installing Battery in RemoteReceiverScrewSwitch Plate WiresFigure 28 - Installing Remote ReceiverInstalling Batteries in Hand-HeldRemote Control Unit1. Remove battery cover on front of re-mote control unit following directionof arrow.2. Insert two AAA batteries following dia-gram in battery housing area.3. Replace battery cover onto remote con-trol unit.Figure 31 - Installing Battery in Hand-Held Remote Control UnitAAABatteriesBatteryCoverRemoteControl UnitBatteryHousingFigure 29 - Connecting WiresRed Wire FromReceiverValveWhite WireFrom ReceiverINSTALLING BATTERIESFOR RM4Four AA and two AAA batteries (not in-cluded) are required to operate this heaterwith the wireless hand held remote controlset. AA batteries must be installed in thereceiver and AAA batteries in the hand-heldremote control unit.Note: Only use alkalinebatteries.Installing Batteries in Receiver1. Locate back of receiver behind the re-mote switch bracket under the fireboxbottom.2. Slide the battery door off of the receiverin the direction of the arrow on the door.3. Insert the four AA batteries accordingto Figure 30.4. Slide the battery door back into position.Remote ReceiverScrewsRemote SwitchBracketBattery DoorAA BatteriesRemoteReceiverIgnitorNutsTerminalWires++---+++--+