Desa Comfort Glow LFP33PR Owner's Operation And Installation Manual

Contents

9104888OWNER’S MANUALINSTALLATIONContinuedFigure 11 - Inserting Fireplace Into CabinetMantelFigure 10 - Location of Nailing FlangesNailingFlangesContinuedActual FramingHeight 32 3 /8" 33"Front Width 34 5 /16 " 35 1/2 "Depth 16 11 /16 " 17 3/4 "35 1/ 2"17 3/ 4"33"Figure 12 - Rough Opening for Installingin WallBUILT-IN FIREPLACEINSTALLATIONBuilt-in installation of this fireplace involvesinstalling fireplace into a framed-in enclo-sure. This makes the front of fireplace flushwith wall. If installing a mantel above thefireplace, you must follow the clearancesshown in Figure 15, page 10. Follow theinstructions below to install the fireplace inthis manner.Figure 14 - Attaching Fireplace to WallStudsNailing FlangesNails orWoodScrews39 3/8"27 7/8"55 5/8"35 1/2"Figure 13 - Rough Opening for Installingin Corner1. Frame in rough opening. Use dimen-sions shown in Figure 12 for the roughopening.If installing in a corner, use dimensionsshown in Figure 13 for the rough open-ing. The height is 33" which is the sameas the wall opening above.2. If using blower, install and properlyground GA3555, three-prong 120 voltelectrical outlet, in fireplace. Followinstructions included in kit (see Acces-sories, pages 24 and 25).3. Install gas piping to fireplace location.This installation includes an approvedflexible gas line (if allowed by localcodes) after the manual shutoff valve.The flexible gas line must be the lastitem installed on the gas piping. See In-stalling Gas Piping to Fireplace Loca-tion, page 10.4. Carefully set fireplace in front of roughopening with back of fireplace insidewall opening.5. Attach flexible gas line to gas supply.See Connecting Fireplace to Gas Sup-ply, page 11.6. Plug electrical cord into electrical out-let installed in step 2.7. Carefully insert fireplace into roughopening.8. Attach fireplace to wall studs usingnails or wood screws through holes innailing flange (see Figure 14).9. Check all gas connections for leaks. SeeChecking Gas Connections, page 12.10. Install brass trim after final finishingand/or painting of wall (see Figure 6,page 7).11. Carefully insert fireplace into cabinetmantel. Be careful not to scratch ordamage hearth base, cabinet mantel, orany laminate trim on hearth base. Re-move protective material from top ofhearth base and from front of fireplace(if any).Note: You can secure fireplaceto hearth or floor. Open lower louver.Locate screw holes in bottom of base.Tighten wood screws through theseholes and into hearth or floor.12. Check all gas connections for leaks. SeeChecking Gas Connections, page 12.