Desa SVYD18NRA Series Owner's Operation And Installation Manual

Also see for Victor Hearth: OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

www.desatech.com 113084-01C10INSTALLATIONContinued9. Remove log box and heater from carton. Placeheater in stove as shown in Figure 9. Use boltsfrom hardware kit to attach heater to stove.10. Install door catch bolt (M8 x 1.25-55mm withtwo M8 hex nuts) into threaded hole on stovebody (see Figure 7). Use an adjustable wrenchor a 12mm socket. The catch bolt has two hexnuts attached to it (see Figure 11). The top nutis a bolt stop and the bottom nut is for doorleveling adjustment.11. Check general catch bolt alignment with doorclaw. Make final adjustment and door level-ing after stove is in normal standing position.12. Carefully lift stove back up on its four attachedlegs.13. Remove gas log heater from carton.Note: Donot pick up gas log heater by the burner itself.This could damage heater. Always handle thegas log heater by the heater base only.14. Fasten stove pan to stove with two (2) M6x 1 - 25mm bolts. Use a flat washer and lockwasher with each bolt. Tighten bolts intothreaded holes on stove body (see Figures7 and 9). Use an adjustable wrench or a10mm socket.15. Set top grates into stove top.Figure 7 - Locating Threaded Holes forStove Bottom, Legs, and DoorAttachment (Appearance May VaryDepending on Model)LegHoleLeg HoleLeg HoleLeg HoleDoor HingeStep Bolt HoleDoor Catch BoltWith AdjustableHex Nuts HoleHoles forStoveBottomFrontBottom OfStove UnitFigure 8 - Attaching Stove Legs(Oxford™ Model Shown)Bottom OfStove UnitLegBoltWashersFigure 9 - Attaching Stove Pan(Oxford™ Model Shown)Threaded Holesin Stove BodyBoltWashersStove PanFigure 10 - Attaching Stove Door(Appearance May Vary Depending on Model)StoveBottomStepBoltDoorHingeThreadedHoleStoveDoorBolt ShoulderFigure 11 - Catch Bolt and Door ClawOrientationAdjustingNutBolt StopCatchBoltDoorClawDoor