Desa V)G36HR Owners Manual And Installation Manual

Also see for (V)G36: OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

www.desatech.com 116010-01E12glass door insTallaTionFigure 20 - Installing Top Door FrameTop DoorRailSmoke ShelfIMPORTANT: Install glass doorframe before installing glassdoor.INSTALLING DOOR FRAMES1. Remove screws from smoke shelf (seeFigure 20).2. Mount top door frame and secure withscrews removed in step 1.3. Remove center brick by pulling ring handle(see Figure 21).4. Remove ash box.5. Remove three screws located at front offirebox (see Figure 21).6. Align bottom rail mounting holes withholes at front of firebox and secure withscrews removed in step 5.7. Place ash box in place. Replace centerbrick.DOOR ADjUSTMENTRemove doors and slightly loosen lower pivotclips and upper spring clips. Replace doors andfully close them. Use 1/8" shims (any material)to level doors. Once proper setting is achieved,carefully open doors enough so that you canaccess spring clips with a phillips screwdriver.Tighten screws. See Figure 23.Figure 22 - Installing Bi-Fold DoorsSpringClipInsert Pininto SpringClipPivotHoleInsertBottomPivot Pininto HoleFold Doorand SlideTop PinsInto TrackFigure 23 - Adjusting Bi-Fold DoorsFigure 21 - Installing Bottom Door RailBottomDoor RailAsh BoxCenterBrickRingHandleScrewsINSTALLING GLASS DOORSSpring clips have been installed but someadjustments may be needed. If doors do notclose properly or do not appear straight, seeDoor Adjustment.1. With bi-fold doors completely folded, insertbottom pivot pin into pivot hole locatednear bottom corner of front face openingand swing door to vertical position makingsure top pins slide into door track. Dooris installed when top door pin snaps intospring clip (see Figure 22).2. Repeat step 1 for remaining door.If you find the doors do not close properly ordo not appear level or straight, proceed withsection on door adjustment.SpringClip