Desa (V)T32EP-A SERIES, (V)T32EN-A SERIES Owner's Operation And Installation Manual

Also see for (V)T32EN-A Series, (V)T32EP-A: OWNER'S OPERATION AND INSTALLATION MANUAL

www.desatech.com116647-01B 3Removing Glass DoorIf replacement of glass is necessary, the entireassembly, glass and frame, must be replaced. Ifglass is broken, wear gloves and tape the remainingfragments onto the frame.1. Remove screen assembly by pushing the rodeither left or right and then down and forwardto remove screen/rod assembly from the fire-box. Set assembly aside.2. Lift up on latches to unlock. There are two ontop of firebox and two below firebox that holdglass door in place (see Figure 37).3. While holding glass door to prevent it fromfalling and causing injury, remove the fivescrews from the hinge located on the left sideof door frame assembly (see Figure 37).4. Remount the new frame at the hinge with fivenew screws before closing door. This willensure seating of the gasket.5. Close glass door frame. Lock latches by placingthe bar under the tab on door and pushing downand back on latch (see Figure 37).FIREplaCEINSTallaTIONContinuedFigure 36 - Removing Louver PanelLouver PanelSpring LatchFigure 37 - Removing/Replacing GlassDoorLockUnlockGlass FrameAssemblyScrewHingeLatch6. Replace screen/rod assembly by reversingstep 1.7. Replace louvers by reversing procedure underRemoving Louver Panels, page 22Cleaning Glass DoorSee Cleaning and Maintenance on page 28.INSTALLING OPTIONAL BRICKLINER MODEL bL32DWARNING: If fireplace hasbeen running, turn off and un-plug fireplace. Let cool beforeinstalling brick liner.This brick liner kit is optional. You may purchasebrick liner from your local retailer or see page 37.CAUTION: Always handlebrick panels with two hands.Do not force brick panels intoplace. Excessive force will breakbrick panels.1. Remove top and bottom louvers to allow accessto door latches.2. Unlock door latches and open glass door. Seesteps 1 and 2 of Removing/Replacing GlassDoor, page 22.3. If installing brick liner in new fireplace, go tostep 4. If installing brick liner in an existingfireplace, carefully remove logs, lava rock andember material.4. Remove three screws from deflector shield onthe inside top of firebox. Set shield and screwsaside.5. Install rear brick panel first. Rest bottom edge ofpanel on back edge of grate (see Figure 38).Figure 38 - Installing Rear Brick PanelRear BrickPanel