Desa VDCFRNA Owner's Operation And Installation Manual

Contents

www.desatech.com 113133-01B24OPERATING FIREPLACEContinued5. Press in and turn control knob counter-clockwise to the PILOT position.Press in control knob for five (5) seconds(see Figure 39).Note: You may be running this fireplace forthe first time after hooking up to gas sup-ply. If so, the control knob may need to bepressed in for 30 seconds or more. This willallow air to bleed from the gas system.6. With control knob pressed in, press andrelease ignitor button. This will light pilot.The pilot is attached to the front burner. Ifneeded, keep pressing ignitor button untilpilot lights.Note: If pilot does not stay lit, contact aqualified service person or gas supplier forrepairs. Until repairs are made, light pilotwith match. To light pilot with match, seeManual Lighting Procedure.7. Keep control knob pressed in for 30 secondsafter lighting pilot. After 30 seconds, releasecontrol knob.• If control knob does not pop out whenreleased, contact a qualified service personor gas supplier for repairs.Note: If pilot goes out, repeat steps 4through 8.8. Slightly push in and turn control knob coun-terclockwise to the ON position.9. Set flame adjustment knob to any levelbetween HI and LO.CAUTION: Do not try to ad-just heating levels by using theequipment shutoff valve.Figure 39 - Control Knob and IgnitorButton Location (Shown as Supplied- No Control Options)PiezoIgnitorButtonControlKnobFlameAdjustmentKnobFigure 40 - Propane/LP Gas PilotIgnitorElectrodePilotBurnerFigure 41 - Natural Gas PilotIgnitorElectrodePilot BurnerTO TURN OFF GASTO APPLIANCEShutting Off Fireplace1. Turn control knob clockwise to theOFF position.2. If Using Optional Hand-Held Remote:Set selector switch in the OFF position toprevent draining battery.Shutting Off Burners Only (pilot stays lit)You may shut off the burners and keep the pilotlit by doing one of the following:1. Turn control knob clockwise to thePILOT position.2. If Using Optional Hand-Held Remote: Useremote control manual OFF button.WARNING: Make sure re-mote sensor selector switch isin the OFF position when youare away from home for longperiods of time.MANUAL LIGHTINGPROCEDURE1. Follow steps 1 through 5 under LightingInstructions, starting on page 23.2. Depress control knob and light pilot withmatch.3. Keep control knob pressed in for 30 secondsafter lighting pilot. After 30 seconds, releasecontrol knob. Now follow steps 8 and 9under Lighting Instructions.