Desa VGC30NR/PR Owner's Operation And Installation Manual

Also see for VGC18NR: Owner's manual Instruction manual OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

Desa VGC30NR/PR Owner's Operation And Installation Manual Manual pdf 19 page image

www.desatech.com119162-01B 19INSTALLATIONContinuedFigure 28 - Installing Log #7OPERATING HEATERFOR YOUR SAFETYREAD BEFORE LIGHTINGWARNING: If you do not fol-low these instructions exactly,a fire or explosion may resultcausing property damage, per-sonal injury or loss of life.A. This appliance has a pilot which must belighted by hand. When lighting the pilot,follow these instructions exactly.B. BEFORE LIGHTING smell all around theappliance area for gas. Be sure to smell nextto the floor because some gas is heavier thanair and will settle on the floor.WHAT TO DO IF YOU SMELL GAS• Do not try to light any appliance.• Do not touch any electric switch; do notuse any phone in your building.• Immediately call your gas supplier froma neighbor’s phone. Follow the gassupplier’s instructions.• If you cannot reach your gas supplier, callthe fire department.C. Use only your hand to push in or turn thegas control knob. Never use tools. If theknob will not push in or turn by hand, don’ttry to repair it, call a qualified service tech-nician or gas supplier. Force or attemptedrepair may result in a fire or explosion.D. Do not use this appliance if any part hasbeen under water. Immediately call aqualified service technician to inspect theappliance and to replace any part of thecontrol system and any gas control whichhas been under water.Figure 27 - Placement of Embers7EmberMaterial6. Add embers to front flat burner. Gently removeembers from the bag using gloves or tweezers.(This material is a skin irritant. Glovesor tweezers are recommended to preventskin irritation). Separate pieces of embermaterial and place over surface of flat burner(see Figure 27). Spread ember material evenlyover surface for greatest glowing effect. DoNOT place ember material anywhere elseon the unit. Use only ember material sup-plied with unit. Excessive ember materialmay produce carbon monoxide or soot.WARNING: Do not use rockwool or any other ember materialnot supplied with this unit.WARNING: Do not operateunit without ember materialcorrectly in place as shown inFigure 27.7. Place center crossover log (#7) onto pin on log#5 and resting on grate as shown in Figure 28.Log #7 must overlap grate and rest against gratefinger. Log must not rest on burner.8. Add lava rock and small decorative logsaround base of heater if desired. DO NOTplace rock or additional logs on frontburner or on logs. Placing any material onunit other than ember material on front burnermay result in production of carbon monoxideor soot. Use lava rock to hide wires fromswitch/log to control valve. Place switch/logso the switch is easy to access.Flat FrontBurner