Desa Vanguard VI33NRB Owner's Operation And Installation Manual

Also see for Vanguard VI33NRB: OWNER'S OPERATION AND INSTALLATION MANUAL

Desa Vanguard VI33NRB Owner's Operation And Installation Manual Manual pdf 18 page image

www.desatech.com 113195-01A18INSTALLATIONContinuedOPTIONAL WIRELESS HAND-HELDREMOTE CONTROL ACCESSORIES(GHRCB and GHRCTB)Installing Remote Receiver Unit1. Disconnect switch wires from the controlvalve.2. Remove screws attaching switch plate.3. Remove switch plate (see Figure 26). Discardafter removing.4. Install remote receiver unit onto gas log heaterbase using mounting clips.5. Push clips firmly into place (see Figure 27).6. Connect wires as shown in Figure 28.Figure 26 - Switch Plate and WiringHarnessScrewSwitchPlateWiresRemote SwitchBracket IgnitorFigure 27 - Installing Remote ReceiverFigure 28 - Connecting WiresRed WireFrom ReceiverValveWhite WireFromReceiverRemoteReceiverMountingClipsINSTALLING 9-VOLT BATTERIESTwo 9-volt batteries (not included) are required tooperate this heater with the wireless hand-heldremote control set. Install one battery in the re-ceiver and one in the hand-held remote controlunit. Note: Only use alkaline batteries.Installing 9-Volt Battery (Not Included) inReceiver1. Locate back of receiver under front burner ofheater.2. Locate the battery clip mounted on the backof the receiver.3. Slide a 9-volt battery through the clip.4. Attach the terminal wires to the battery.Figure 29 - Installing Battery in RemoteReceiverBatteryClip9-Volt BatteryTerminalWiresRemoteReceiverFigure 30 - Installing Battery in Hand-HeldRemote Control Unit (GHRCB Series)Battery Cover9-Volt BatteryTerminalWiresRemoteControl UnitBatteryHousingFigure 31 - Installing Battery in Hand-HeldRemote Control Unit (GHRCTB Series)9-VoltBatteryRemoteControlUnitBatteryCoverTerminalWires