www.desatech.com113195-01A 523. Refractory, glass doors, screen rails, screenmesh and solid-fuel log grates (if applicable)can be removed from the fireplace before in-stalling the unvented fireplace insert.24. Smoke shelves, shields and baffles may beremoved if attached by mechanical fasteners.LOCAL CODESInstall and use fireplace insert with care. Followall local codes. In the absence of local codes, usethe latest edition of The National Fuel Gas Code,ANSI Z223.1/NFPA 54*.*Available from:American National Standards Institute, Inc.1430 BroadwayNew York, NY 10018National Fire Protection Association, Inc.Batterymarch ParkQuincy, MA 02269UNPACKINGCAUTION: Do not removethe warning and instruction la-bels attached to the heater baseassembly. These markings con-tain important warranty andsafety information.1. With utility knife, cut the carton all the wayaround above the staples on the bottom tray.Lift the carton off the heater. Remove pack-ing.Note: The hood is located in the packingon the right hand side of the heater front. Liftthe heater off the bottom tray.2. Locate two screws above top corners of thefireplace insert screen. Remove and discardthese screws. Lift fireplace insert screen upand pull out to remove.3. Remove protective packaging applied to logs,log base assembly, and fireplace insert.4. Remove fireplace insert hood from cartoninsert.5. Check all items for any shipping damage. Ifdamaged, promptly inform dealer where youbought fireplace insert.SAFETY INFORMATIONContinuedPRODUCTIDENTIFICATIONFigure 1 - Log Base AssemblyFigure 2 - Fireplace InsertTop Louver AssemblyFireboxHoodBottom LouverAssemblyScreenAssemblyFireboxSupportOFFPILOTONHILOThree PieceLog SetRemote SelectorSwitch (Optional)PiezoIgnitorOptionalRemoteControlControlKnobsTop OuterCasingBlowerAssemblyGas LineAccessREMOTE CONTROLACCESSORIESThere are four optional remote controls that canbe purchased separately for this fireplace insert:• wall switch• wall thermostat• hand-held ON/OFF remote• hand-held thermostat remoteSee Accessories, page 34.