4 Installing and removing the standDX-40L150A11Installing and removing thestandYou must install your TV into the stand in order for it to stand upright ona cabinet or other flat surface. If you intend to mount your TV on a wallor other vertical surface, you must remove the stand column.Cautions• Read these instructions carefully before you try to assemble thestand or remove the stand column.• Make sure that you handle the TV carefully when attempting toassemble or remove the stand. If you are not sure of your abilityto do this, contact a professional installer or service technician.Dynex is not responsible for any damages or injuries that occurbecause of mishandling or incorrect assembly.• Use a soft cushion or covering to prevent scratching or damage tothe TV screen or cabinet.• Before assembly or removal of the stand, unplug the power cord.Installing the standTo install the stand:1 Remove the stand from the box and place it on a table or bench.2 Lay the TV on a flat, cushioned surface.3 Align the stand with the TV, as shown in the followingillustration.4 Secure the stand to the column with the four screws provided.Installing a wall-mount bracketTo install a wall-mount bracket:1 Lay your TV face down on a table or bench. Make sure that youput down a soft cushion or cloth so that your TV is not scratched.2 Remove the four screws that secure the TV to the base, thenremove the base.3 Remove the four screws holding the stand bracket to the TV, thenremove the stand bracket.4 Secure the wall-mount bracket to the back of your TV using fourM6 screws (not provided).Caution: You must be mindful of the length of the screws used to mountthe wall mount bracket to the back of your TV. The screws must be10-12 mm in length. Using shorter screws could result in an insecuremount. Using longer screws could cause a space between the wallmount bracket and the TV.200 mm200 mmM6 screws