Changing channel settings 15Selecting the audio modeYou can select the audio mode for analog channels.To select the audio mode for analog channels:• Press MTS/SAP on the remote one or more times. You can select:• MONO—Select this option if there is noise or static on weakstereo broadcasts.• STEREO—Select this option for programs broadcast instereo.• SAP—Select this option to listen to a secondary audioprogram, if available.Note: Mono is automatically selected if the program is broadcast inmono.To select an audio track for a digital channel:• Press MTS/SAP. If an audio track is available, it plays.Playing TV audio onlyYou can turn off the picture on your TV and listen to only the programaudio.To play only the TV audio:1 Press MENU. The on-screen menu opens.2 Press or to highlight Setup, then press . The Setup menuopens.3 Press or to highlight Audio Only, then press or toselect On.4 Press EXIT to close the menu.Notes:Audio Only works only when the input source is TV and your TV isreceiving a broadcast signal.To exit Audio Only mode, press any button. When you exit Audio Onlymode, the Audio Only option is automatically reset to Off .Changing channel settingsAutomatically scanning for channelsTo auto scan for channels:1 Press MENU. The on-screen menu opens.2 Press or to highlight Channel, then press . The Channelmenu opens.3 Press or to select Air or Cable.4 Press or to highlight Auto Scan, then press ENTER. Aconfirmation box opens.5 Press or to select Yes, then press ENTER to start the scan. Aprogress box shows the progress of the scan.Parental Controls