4 Installing and removing the stand3 Gently push down on the TV until it clicks into place.Adjusting the viewing angle of the TVTo adjust the viewing angle:• Adjust the angle forward up to 5° and backward up to 10°.Caution: When adjusting the angle, use caution to avoid slipping ortipping the TV.Removing the standTo remove the stand from the stand column:1 Lay your TV face down on a table or bench. Make sure that youput down a soft cushion or cloth so that your TV is not scratched).2 Adjust the stand so that the angle between the stand and the TVis 90°.3 Press the two black tabs on the bottom of the stand together andpush them into the stand column, then pull the stand off thestand column.Installing a wall-mount bracketIf you want to attach the TV to a wall-mount bracket (not provided), youshould first remove the stand pedestal if it is pre-attached.To remove the stand column:1 Lay your TV face down on a table or bench. Make sure that youput down a soft cushion or cloth so that your TV is not scratched).2 Remove the four screws holding the stand column to your TV,then remove the stand and the stand column.Note: The appearance of this product in these illustrations may differfrom your actual product, and is for comparative purposes only.To attach your TV to a wall-mount bracket:Warning: These servicing instructions are for use by qualified servicepersonnel only. To reduce the risk of hazards, do not perform anyservicing other than that contained in the operating instructionsunless you are qualified to do so.1 Remove the four screws holding the TV to its base, as describedabove.2 Secure the wall-mount bracket to the back of your TV using thefour M4*10 screws provided with the bracket.Press the black tabs together andpush them into the stand column.Pull off the stand.Stand Remove four screws