Making connections 9DX-L40-10AConnecting an antenna, cable TV, orsatellite TV boxImportant: The antenna connector should only befinger-tightened. Do not tighten this connector with anytool, or you may damage your TV.To connect an antenna, cable TV, or satellite TV box:1 Turn off the TV before connecting the antenna.2 Connect one end of a coaxial cable (notincluded) to the RF OUT jack on the antenna oron the cable or satellite TV box. If you are usingan antenna with twin-lead cable, you may needa 300-75 ohm adapter (not provided) toconnect it to the back of your TV. Likewise, ifyou are using several antennas, you may need acombiner (not provided).3 Connect the other end of the cable to theANT/CABLE IN jack on the side of your TV.Notes:Use a coaxial cable to eliminate interference and noise fromradio waves.Do not bundle the coaxial cable with the power cord or othercables.If the antenna is not installed correctly, contact qualifiedservice personnel to correct the problem.Connecting a VCRTo connect a VCR:1 Make sure that your TV’s power cord isunplugged and the VCR is turned off.2 Connect an AV cable to the AV VIDEO andAUDIO out jacks on the VCR.3 Connect the other end of the AV cable to theAV2 VIDEO and L and R audio jacks on the backof your TV.Home antennaterminal (75 ohm)ANT/CABLE IN jack (onthe side of the TV)Twin-lead flat cableRF coaxial cable (75 ohm)RF coaxial cable (75 ohm) RF coaxial cable (75 ohm)RF coaxial cable (75 ohm)Twin-lead flat cableCombiner (not provided)300-75 ohm Adapter(not provided)VHF antenna UHF antennaVHF, UHF, orcombinationantennaHEADPHONEAntenna, cableTV, or satellite boxSide of TVHDMI3 HDMI2COMP2VIDEO L RAV2RCOMP1AUDIO INVGA VGAL RAUDIO OUTY P B R L RLL RBack of TVAV cableNote: Cables are oftencolor-coded to connectors.Connect yellow to yellow,red to red, and white towhite. Cables may beseparate or combined.DX-L40-10A_09-0537_MAN_ENG_V1.book Page 9 Tuesday, July 28, 2009 10:07 AM