Dynex DX-UPDVD2 User Manual

Also see for DX-UPDVD2: Manual User guide Quick setup guide Guía del usuario Guide de l'utilisateur

Contents

Specifications 11DX-UPDVD2Cleaning discsFingerprints and dust on the disc can cause poor picture quality andsound distortion. Before playing, clean the disc with a clean cloth. Wipethe disc from the center out.Do not use strong solvents such as alcohol, benzine, thinner,commercially available cleaners, or anti-static spray intended for oldervinyl records.Note: Never operate this player immediately after moving it from a coldlocation to a warm location. Leave it for two or three hours withoutoperating it. If you use this product in such a situation, it may damagediscs or internal parts.Resetting your playerReset your player if you observe any of the following symptoms:• Your player is plugged in, but the power will not turn on oroff.• The display window is not working.• Your player does not operate normally.To reset your player:• Unplug the power cord for 30 minutes, then plug in thepower cord again.SpecificationsSystem and outputsGeneralLegal noticesFCC Part 15This device complies with Part 15 of the FCC Rules. Operation of this product is subjectto the following two conditions: (1) this device may not cause harmful interference, and(2) this device must accept any interference received, including interference that maycause undesired operation.This equipment has been tested and found to comply within the limits for a class Bdigital device, pursuant to Part 15 of the FCC Rules. These limits are designed to providereasonable protection against harmful interference in a residential installation. Thisequipment generates, uses, and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in aparticular installation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off and on, theuser is encouraged to try to correct the interference by one or more of the followingmeasures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to whichthe receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.FCC warningChanges or modifications not expressly approved by the party responsible forcompliance with the FCC Rules could void the user’s authority to operate thisequipment.NoticesSpecifications and features are subject to change without notice or obligation.For service and support call (800) 305-2204.VF Signal system NTSCFrequency response CD: 20 Hz~20 KHz (EIAJ)DVD: 20 Hz~44 KHz (96 KHz)(Sample result)20 Hz~22 KHz (48 KHz)(Sample result)Audio S/N ratio > 90 dBAudio MPEG LAYER2 standardAudio output (analogaudio) Electric level output: 1.8 ± 0.2 VResistance: 10 KohmAudio output (digitalaudio) Electric level output: 0.5 V p-pResistance: 75 ohmComposite videooutput Electric level output: (1.0 ± 0.2) V p-pResistance: 75 ohmUnbalanced negativeComponent video (Y,Cb, Cr) Electric level output: 0.7 V p-pResistance: 75 ohmPower 110~120 V 50/60 HzPower consumption 12 WDimensions (LxWxH) 14.173 x 8.267 x 1.3 inches(359.99 x 209.98 x 33.02 mm)Weight 4.08 lbs. (1.86 kg)Operatingtemperature 41°F to 95°F (5°C to 35°C)Operating humidity 5% to 90%