EBS-6100 Printer User's Manual Paragraph 4 - Operating the Printer EBSInk-Jet Systems® 54 20070529#20.5Terminal key Function¥To assign the read only attribute to every block in thelibrary. The option is available only when the servicepassword is enabled. If the password level is too low, youwill be asked for a password when you make an attempt tochange the attribute.¦To remove the read only attribute from every block in thelibrary. The option is available only when the servicepassword is enabled. If the password level is too low, youwill be asked for a password when you make an attempt tochange the attribute.NOTE:If no parameter blocks are defined in the library, the command is ignored.4.4.3. Printing4.4.3.1. Stopping the PrintingThe printing can be terminated in two parallel and independent ways:• With the STOP PRINTING command on the terminal.• With the PRINT ON/OFF key on the main pad of the external panel (when the keyis pressed, the STOP PRINTING) command is executed). The key can be usedno matter where the cursor position is within the control menu (for example, youcan stop the printing while editing a text file).To stop the printing follow the procedure below.In the main MENU select the PRINTING item and then the STOP PRINTING item,orPress the PRINT ON/OFF key on the external panel.If the command is selected while the printer is in the print mode, the current print jobfinishes and no other label is printed. The execution of the command results in theapplication of high voltage. The green PRINT ON/OFF lamp on the main pad of theexternal panel and the red HV ON lamp on the internal panel go out. The printerswitches to the stop mode.If the printing is to be interrupted immediately (the current print job is not to becompleted), use the QUICK STOP command.4.4.3.2. Starting the PrintingThe printing can be initiated in two parallel and independent ways:• With the START PRINT command selected on the terminal.• With the PRINT ON/OFF key on the main pad of the external panel. When thekey is pressed, the START PRINT command is executed for the text file that wasprinted most recently. The key can be used no matter where the cursor position iswithin the control menu (for example, you can start the printing while editing asubfile).The printing is started in the following way. In the main MENU select the PRINTINGitem and then the START PRINT item.!
