EBSInk-Jet Systems® EBS-6100 Printer User's Manual Paragraph 4 - Operating the Printer20070529#20.5 814.4.6.5. Printer Operation Problems During the Replacement of Ink andSolvent BottlesInk Monitoring System Flow DiagramThe block diagram given below shows the operation of the ink monitoring system, errors thatmay occur and a user’s actions to be taken after the errors have occurred.The following message is displayed after the bottle has been emptied:INK:EMPTY BOTTLE or SOLVENT:EMPTY BOTTLEDetach and remove the empty bottle.Replace it with a new bottle of ink (solvent).DO NOT INSERT ANY SUCTION PIPE INTO THE BOTTLE!!!The following message is displayed:BOTTLE VERIFYING:WAIT 10 SECONDS PLEASEpress the V keypress the V keyThe message:BOTTLE ACCEPTEDThe message:BOTTLE TOO OLDThe message:BOTTLE ALREADY CANCELLEDThe message:WRONG BOTTLEThe message:WRONG BASE LIQUID or SUBTYPEThe message:PIGMENTED/NOMPIGM MISMATCHEDThe message:BOT. FOR OTHER PRNTER TYPEThe message:WRONG COLOURpress the V keyRemove the bottle, insert a suction pipe and re-place the bottle.NOTE:If an alarm is generated and the messageNO BOTTLEdisplayed after the bottle has been removed, clear the messageby pressing the V key and the sound alarm goes outautomatically after the bottle has been put in place.The bottle has already beenvalidated in this or other printerPut a new bottle with the right type of ink(solvent) and clear the message bypressing the V key.Wrong type of ink (solvent).in the maximumof 10 secondsThe message:WRONG SOLV FOR ECON.PRINTER4.5. Alarms, Errors and IndicationsAn alarm condition is indicated with an audible signal generated by an signalling deviceand the red ERROR lamp that is next to the CLR. ALARM key on the external panel. Thereason for an alarm can be identified in a variety of ways:1. The main window of the terminal display shows the message describing the reason for analarm no matter what operation you perform at a given time (e.g. you may be editing
