EBS-6100 Printer User's Manual Paragraph 4 - Operating the Printer EBSInk-Jet Systems® 94 20070529#20.5IJA4A5a a±∆ab b±∆bFig. 4.6.5.1.Thus, if D=4 (see point 1 above) measured distance A4 (see Fig. 4.6.5.1) can be biasedwith error ∆a, and for D=5, measured distance A5 can be biased with error ∆a+∆b.The maximum percentage error described in this section is Ur=((∆a+∆b)/a)*100%.The maximum error which may occur under such conditions provided that the above errorsare not significant, can be expressed approximately as:U=Us+Ut+Up+UrIn the most adverse case, we can obtain the maximum rate that is by U% smaller than thetheoretical value. The values of the above errors depend on specific installation and can varyextremely for various applications. Therefore every case needs to be considered on anindividual basis. For more information on the above you can contact an experiencedserviceperson.4.6.6. The Maximum Print Rate vs. Resolution SettingsThe table below shows the maximum print rate vs. the settings of the Resol. dot/cm printparameter for various print rates (set with the Speed print parameter) and various printheights (7, 16, 25, 32 dots).Maximum Print Rate [m/min]Speed=SLOW MIDDLE FASTPrint Height [dots] Print Height [dots] Print Height [dots]TheResol. dot/cmparameter32 25 16 7 25 16 7 16 79 42 55 65 148 55 130 297 245 59510 37 50 58 133 50 117 267 220 53511 34 45 53 121 45 106 243 200 48712 31 41 48 111 41 97 223 183 44613 29 38 45 103 38 90 206 169 41214 27 35 41 95 35 83 191 157 38215 25 33 39 89 33 78 178 147 35716 23 31 36 83 31 73 167 137 33417 22 29 34 78 29 68 157 129 31518 21 27 32 74 27 65 148 122 29719 19 26 30 70 26 61 140 116 28120 18 25 29 66 25 58 133 110 26721 18 23 27 63 23 55 127 105 25522 17 22 26 60 22 53 121 100 24323 16 21 25 58 21 50 116 95 23224 15 20 24 55 20 48 111 91 223
