Eaton 9140 User Manual
Also see for Powerware 9140: Reference guideUser guideUser guideUser guideInstallation guide
                                          | |
Contents
|
INSTALLATIONEaton 9140 EBM User's Guide 164201623 Rev C www.eaton.com/powerquality264. Replace the EBM front cover and tighten the two front coverscrews (see Figure 12).Figure 12. Replacing the EBM Front Cover5. Continue to the following section, “EBM Installation.”EBM InstallationC A U T I O NA small amount of arcing may occur when connecting an EBM to the UPS. This is normal andwill not harm personnel. Insert the EBM cable into the UPS battery connector quickly andfirmly.To install the EBM(s):1. Verify that all battery circuit breakers are in the OFF (O) position(see Figure 13).2. Remove the cable retention clip from the UPS battery connector.Retain the clip and two screws.3. Remove the cable retention clip from all EBM battery connectorsexcept on the EBM installed in the lowest position in the rack.Retain the clips and screws.4. Plug the EBM cable(s) into the battery connector(s) as shown inFigure 13. Up to four EBMs may be connected to the UPS. |
Related manuals for Eaton Powerware 9140
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine