Eaton 9155 User Manual

Also see for 9PX: Installation and user manual Advanced user's guide Manual Advanced user's guide User guide

Contents

InstallationEaton Bypass Power Module (BPM) User’s Guide P-164000628—Rev 2 www.eaton.com/powerquality 5Rackmount Installation125A BPM Rackmount Hardwired InstallationCAUTIONl The BPM distributes high density power in a small form factor.l Read the complete installation procedure before beginning any electrical wiring.To install the BPM in a rack:1. Install the 4-post rail kit included with the BPM (see Figure 2).Figure 2. Install Rail Kit2. Place the BPM on the rails and push the BPM into the rack.Verify that the breakers are facing the front of the rack and the BPM wiring terminals are facing the rear ofthe rack.3. Push the BPM past the back of the rack to allow access to the rear wire access-point covers and the wireaccess panel cover (see Figure 3).Figure 3. Push BPM into the Rack4. Remove the wire access-point covers (see Figure 4).)Figure 4. Remove the Wire Access-Point Covers